БългарскиEnglish

ELECTRONIC MODULES

BUR2 250 CET two-speed impact drill

Two-half-period regulator for impact drill P= 1010W, soft start, rpm regulation, 11 fixed levels of regulation from A to G speed selectors, non-step regulation from the trigger of the switch, 11 fixed stages of torque control, light indication.

BUR2 350 CET two-speed impact drill

Two-half-period regulator for impact drill P= 1010W, soft start, rpm regulation, 11 fixed levels of regulation from A to G speed selectors, non-step regulation from the trigger of the switch, 10 fixed stages of torque control, light indication.

BUR 150CET impact drill

Two-half-period regulator for impact drill P= 600W, soft start, rpm regulation, 11 fixed levels of regulation from A to G speed selectors, non-step regulation from the trigger of the switch, 11 fixed stages of torque control, light indication.

BPR 241CE rotary hammer

Two-half-period regulator for rotary hammer 710 W, with techno generator, providing very good speed stabilization, soft start, non-step regulation from the trigger of the switch, reduced high speed at idle run. Safety work from – 10 С up to + 40 С.

BP 330CE rotary hammer

Soft start, stageless speed control, regulation of motor speed, light indication, 7 speed control stages due to a potentiometer from 380 to 710 rpm.

BP 540 CE rotary hammer

Two-half-period regulator for rotary hammer with P = 1010W, soft start, rpm regulation and stabilization with tachymeter feedback, work light indication, overload light indication, brushes wear-out indication.

М 1050Е angle grinder

Electronic module for angle grinders with Р = 1200W, 7 stages of rpm regulation due to a potentiometer, progressively growing rotation regime until reaching the rate set by the potentiometer.

MB 1400 CET angle grinder

Two-half-period regulator for angle grinder with P = 1400W, soft start, rpm regulation,, tachymeter feedback, thermal overload protection, accidental switching on prevention.

PMB 1200 CE polisher

Electronic module for polishing machines with P = 1200 W, soft start, rpm stabilization, thermal overload protection, 7 stages rpm regulation due to a potentiometer.

MIX 120 CE

Electronic module for mixers with Input power from 1000 to 1500W, soft start, current protection, thermal protection, rpm regulation and stabilization, accidental switching on prevention, light indication.
Constant Tacho-constant electronics for constant rotation rate.

FSPE 81 jig saw

Electronic module for jig saws, soft start, regulation of the vertical strokes, rpm stabilization due to current feedback, 7 stage rate regulation.

TSB 1300CE sabre saw

Electronic regulator for sabre saws with power input 1300W, smooth increasing of rotation speed, rpm regulation, current overload protection, working environment – from 10 С to + 40 С.